CartTBS PowerCube Case - POWERCUBE-CASE
Product options available below
Released: February 2016
The TBS POWERCUBE is a very compact and intricate piece of FPV gear, but it is not very well protected against dust or debris flying through or impacting the stack. This case provides a layer of protection. It also prevents accidental short-circuts between the positive and negative corners.
This casing is specially designed to cover the PowerCube from top to bottom - with or without the plastic isolator plate. All the connectors are made available via slots and cut-outs on all four sides. Huge openings on the left and right ESC sides allow sufficient airflow through to cool the transistors. Airflow is also ensured for the lower DCDC board with extra cut-outs.
It snaps easily in place for a good snug fit, no screws or adhesive necessary. The top side is reinforced to prevent bending and deformation. BOOT-button on Colibri FC board is accessible.
Compatible with all frames which use the 36 x 36mm mounting pattern with a minimum required height clearance of 30mm. The Lumenier QAV-R/XL has special frame layout which require a thinner case top side and two M3x14 replacement screws to properly mount the PowerCube (see kit options below).
PowerCube frame mounting:
| Frame | Screws required |
| 3mm | 2x M3x8mm | 4mm | 2x M3x8mm |
| QAV-R/XL | 2x M3x14mm and reversed nut bracket |
Note: This product is 3D printed and will have minor insignificant extrusion lines/defects.
Features
- New April: Now includes cut-out for the status LEDs
- Protects the stack against dust and flying debris
- Snaps easily in place
- Designed with airflow in mind
- Light-weight and strong
Specifications
- Product ID: POWERCUBE-CASE
- Revision: February 2016
- Platform: TBS PowerCube
- Mounting: Snaps on top of device - four bumps
- Clearance height: minimum 32mm required
- Material: ABS thermoplastic
- Weight: 9 grams